The IDEAL TCT Blade [Wood] features a 30mm bore (arbor hole), which is a standard size used across the majority of professional and semi-professional circular saws. Before purchasing, verify your saw's arbor size in its manual or on the blade guard. If your saw uses a smaller arbor, reduction rings (sold separately) can often be used to achieve compatibility.

Tooth count directly affects cut quality and speed. A 24-tooth blade removes material aggressively and is best for fast, rough ripping where finish quality is not critical. A 40-tooth blade offers a balance between speed and finish. The 60-tooth IDEAL TCT Blade is optimised for fine finish cuts — it cuts more slowly but produces a significantly smoother edge with minimal tear-out, making it the right choice for cabinetry, furniture, and any application where the cut surface will be visible.

Yes. The Tungsten Carbide Tipped teeth and 60-tooth configuration make this blade effective across a wide range of timber species. It performs excellently on softwoods such as pine and cedar, as well as hardwoods including oak, teak, walnut, and meranti. It is also well-suited for engineered wood products such as MDF, plywood, and laminated boards, where a clean, chip-free edge is essential.

The IDEAL TCT Blade [Wood] is rated to a maximum of 6,000 RPM and a tip speed of 80 metres per second (m/s). Never exceed this rated speed. Always check your circular saw's no-load RPM specification and ensure it does not exceed the blade's maximum rating. Operating a blade beyond its rated speed is a serious safety hazard and will void any warranty.

The package includes the 230mm TCT circular saw blade and a washer set, providing everything needed for a secure and correctly tensioned blade mount on your saw's arbor. No additional hardware is required for standard installation on compatible saws with a 30mm arbor.

This blade is designed for use with standard circular saws. While the 230mm diameter and 30mm bore are common specifications, compatibility with plunge-cut or track saw systems depends on the specific saw model and its blade guard design. We recommend consulting your saw's manual to confirm blade diameter and bore compatibility before use in a plunge-cut application.

Splintering on the top face is typically caused by a low tooth count blade or a dull blade. The 60-tooth TCT configuration of the IDEAL blade significantly reduces tear-out by taking smaller, more frequent bites through the material. For best results, also ensure you are cutting with the good face of the board facing down (as circular saws cut on the upstroke), use a sharp scoring line, and feed the saw at a steady, controlled pace without forcing it through the cut.

Burn marks on timber are usually caused by one of three issues: a dull or resin-clogged blade, feeding the saw too slowly, or using the wrong blade type for the material. First, inspect the TCT teeth for resin build-up and clean with a blade cleaning solution if needed. Ensure you are maintaining a consistent, forward feed rate — pausing mid-cut allows heat to build up. If the blade is worn, the Tungsten Carbide tips can be professionally resharpened, extending the blade's service life considerably.

The IDEAL TCT Blade [Wood] has a 30mm bore. If your saw has a smaller arbor (commonly 20mm, 25.4mm, or 16mm), you will need a reduction ring of the appropriate size to adapt the blade to your saw. Reduction rings are widely available from tool accessory suppliers. Ensure any reduction ring used is rated for the blade's maximum speed and is correctly seated before operating the saw. Never attempt to force a blade onto an incompatible arbor.